Basic things

To take command from FM Receiver convert to the contacted servos and motors


Motor for speed

2 Servo in different degree both start with 90 degree if I posh the remote gear up servo goes to 180 degree if I pull down servo go to 0 degree

this what i men 

i don't how i program the arduino and wear to put the input and the output in my arduino   

  I controlled the servo and motors direct from the receiver 

  Now I want to control them throw Arduino   

 ] using remote control 

thanks 

thinks PaulS 

I have done this before. Now I want to do it with Arduino   

thinks 

Hi there, 


I am beginner in Arduino Uno. In addition I have basic knowledge about electronics and programing. I am planning to do airship ((blimp)) for UAE National Day. Everything’s perfect from mechanical side except the programing. I don’t how to program the arduino uno codes. Please help me with the prepared codes and how I can I fix the input and output (where I put the signal wires) in my arduino uno.

The tools which I have are:

3 servos
2 motors with speed control
2 LED with resister
1 FM receiver - 8channel (Futaba -R168DF)
1 remote control (Futaba - T6EXP) - (PCM 1024)
1 battery 7.25 V 

Please Help me  with it

thanks