Yes you re right. no schematic at all.
but there are only a few resistors (to few for a voltage divider)
i think they are only pullups
i have had the hope that anybody did this with this modules already.
thanks

Hi all.

I got this sd card shield here: http://www.ebay.com/itm/330658250543?ssPageName=STRK:MEWNX:IT&_trksid=p3984.m1439.l2648
There it is written: Support 5V/3.3V input.

Now i try to conect it to my arduino uno.

Here the question: Do i have to add a level shifter?
Is there a way to connect it directly? (perhaps switch arduino uno to 3.3V ???

thanks a lot

Hi there.

Does anybody have a solution for this problem?

I also got it and tried to install Arduino 1.0 on two PCs.
But on both i got the same errors as described above.

Thanks a lot and kind Regards!

Aticio