Show Posts
Pages: 1 2 [3]
31  Topics / Home Automation and Networked Objects / Re: AC Phase Control on: February 15, 2012, 08:34:56 am
Although new, but you may try is, use Relays and some capacitors which stores charges until some amount of volts it gets, even don't know it's names and even some diods are there which limits or gives desired/fixed voltages and may use pots which may supports AC...

Silly... Please ignore if you don't get any clue from such answers... Just to divert mindsets to get more idea !!!
32  Using Arduino / Installation & Troubleshooting / Re: Problem uploading - stk500_getsync(): not in sync: resp=0xe0 on: January 28, 2012, 09:03:25 am
Thank you moderators for posting my older post regarding error. But looking to verbose (File-Preference-Verbos) i instantly figured out that, there was common (Tools-Serial Port-Com8) which was already used by Arduino board too. So I changed to any other available (Tools-SerialPort-Com13) and my program/sketch worked fine. I think i may have changed it accidently !!!

Again, posting so that another users may get some help.
33  Using Arduino / Installation & Troubleshooting / Re: Problem uploading - stk500_getsync(): not in sync: resp=0xe0 on: January 28, 2012, 08:47:34 am
I'm too very new in this field, just purchased Uno Rev 3, run first blink Led demo and it worked very fine. changed in parameters of blinking and delay timings and that too worked fine. After i closed it, Arduino 1.0, now even with same program of blinking led, when i compile/run it works, it uploads too with done uploading and after that following error and new program is not working, old program which was worked fine, still runs fine on board but can't upload it again due to this error.

avrdude: stk500_getsync(): not in sync: resp=0x00

Now, with little knowledge of electronics and very new to Arduino, can't solved this error.

Can anybody please let me help where to look or what can be my mistake ?
34  Using Arduino / Installation & Troubleshooting / Re: Arduino Uno, green light won't turn on, windows 7 64bit on: January 28, 2012, 08:30:37 am
That might be due to driver not installed problem or driver is not correctly installed.

Start-ControlPanel-Device Manager-Ports>Update Driver->From My Location->Select Driver folder of Arduino (unzipped one) and there is Arduino Uno.inf file, select that if it is not auto selected.

This way, you may install driver correctly and might work fine.
Pages: 1 2 [3]