Show Posts
Pages: [1]
1  Using Arduino / Installation & Troubleshooting / Re: How to install UNO Rev3 board with Arduino IDE 1.0 on: February 26, 2012, 12:53:54 am
Thanks for clarifying how the IDE functions for all versions of UNO.  How to I install the correct UNO R3.inf?  Do I manually use the control panel>hardware>device manager>update driver to re-install the UNO R3.inf?  And if I do that, how can I get my FTDI driver back to run my Duemilanove on the same computer?
2  Using Arduino / Installation & Troubleshooting / How to install UNO Rev3 board with Arduino IDE 1.0 on: February 25, 2012, 09:56:49 pm
How to configure a new UNO Rev 3 board with a new install of IDE 1.0.  The tools>board menu has a Arduino UNO selection but the drivers folder has BOTH ARDUINO UNO.INF and ARDUINO UNO REV 3.INF?  There is no entry in the tools>board menu for REV 3.
Pages: [1]