I have a handful of atmega8 chips. Can I use one of it on breadboard, to implement ISP, using the ISP sketch?
I did the following-
1. Uploaded sketch to atmega8 on breadboard with NG bootloader
2. Connected digital pins 10,11,12,13 of ISP to the corresponding target pins.
3. Through the usb-break-out board, tried to program the target chip.
I tried it but in vein
I don't find any electrical connection mistake in my circuit.
Due to some reasons, is it non-feasible to implement arduino-as-isp on atmega8/Ng board?