Show Posts
Pages: [1]
1  General Category / General Discussion / Breadboard Schematics on: April 21, 2012, 05:39:00 pm
Does anybody know how the neat breadboard schematics used by jeremy blum or in some of the examples on here are developed??
2  Using Arduino / Sensors / Re: Honeywell Gauge Pressure sensor on: April 21, 2012, 05:36:11 pm
Thank you so much for the help! Got it to work perfectly
3  Using Arduino / Sensors / Re: Honeywell Gauge Pressure sensor on: April 12, 2012, 06:56:45 am
Hi Lefty Thanks for the quick reply,

Im using the arduino for just a small aspect of my project so I would only be a novice when it comes to programming so please bear with me.
Ive used the following code but seem to be getting very fluctuating readings:

int analogPin = 2;     //  connected to analog pin 2
                       // outside leads to ground and +5V

int samples[8];
int i;
int pressure=analogRead(analogPin);


void setup()
{
  Serial.begin(9600);          //  setup serial
}

void loop()
{
  for (i=0;i<=7;i++){ // gets 8 samples of pressure
  pressure = analogRead(analogPin);    // read the input pin 
 
  long pressure = 950 + pressure / 8.5;  //convert it to milli bars
  Serial.print("\t pressure = ");
  Serial.print(pressure);   // print the pressure
  Serial.println(" mb");
 
 
  delay(5000);   // wait 5 second before next sample
     
}


An example of my reading would be it would start at a value of say 750mb, then go 0mb..0mb then when I apply pressure using a syringe it would jump up to 1bar,But then go 0mb..0mb then 1bar etc.
4  Using Arduino / Sensors / Honeywell Gauge Pressure sensor on: April 11, 2012, 12:11:52 pm
Hi,

Im trying to wire up and code a Honeywell gauge pressure sensor to an uno as part of my final year collage project. Does anybody have any experience with using such a pressure sensor? I have attached an image of the sensor and datasheet. Any replies would be greatly appreciated  smiley
Pages: [1]