Show Posts
Pages: [1]
1  Forum 2005-2010 (read only) / Troubleshooting / Re: Sketch size 0 bytes? on: February 10, 2009, 10:05:01 pm
Yeah thats what I'm thinking too. I'm also running Debian etch. I'll look for updated versions when I get some time/patience.
2  Forum 2005-2010 (read only) / Troubleshooting / Re: Sketch size 0 bytes? on: February 09, 2009, 09:27:04 pm
I tried selecting the board again, and the java console threw a whole bunch of warnings about various cpp files:

example:
Stepper.cpp:1: warning: -ffunction-sections may affect debugging on some targetsIn file included from Stepper.cpp:48:

The sketch still fails and shows 0 bytes.

However I thought more about trialex's response and dug up an older version of the ide (0011 alpha) that I had on my filesystem and tried the same sketch there. It worked. So something with this newer version - 0013 is causing me problems. Maybe I'll try building from source.
3  Forum 2005-2010 (read only) / Troubleshooting / Re: Sketch size 0 bytes? on: February 09, 2009, 10:24:41 am
Thanks for the reply.

Standard blink example:

/*
 * Blink
 *
 * The basic Arduino example.  Turns on an LED on for one second,
 * then off for one second, and so on...  We use pin 13 because,
 * depending on your Arduino board, it has either a built-in LED
 * or a built-in resistor so that you need only an LED.
 *
 * http://www.arduino.cc/en/Tutorial/Blink
 */

int ledPin = 13;                // LED connected to digital pin 13

void setup()                    // run once, when the sketch starts
{
  pinMode(ledPin, OUTPUT);      // sets the digital pin as output
}

void loop()                     // run over and over again
{
  digitalWrite(ledPin, HIGH);   // sets the LED on
  delay(1000);                  // waits for a second
  digitalWrite(ledPin, LOW);    // sets the LED off
  delay(1000);                  // waits for a second
}
4  Forum 2005-2010 (read only) / Troubleshooting / Sketch size 0 bytes? on: February 08, 2009, 11:17:26 pm
I've tried searching for this but haven't really found this exact issue:

I have a free duino decimilia.

I'm currently just testing the example sketchs that come with the IDE. I click upload and see the RX/TX leds blinking away so it looks like its transferring the sketch. But the IDE comes back and says "Binary sketch size: 0 bytes. (of a 14336 byte maximum)." And the sketch doesn't run on the board. Just sits there doing nothing. The LED on pin 13 just kind of stays lit rather than blinks (regardless of the sketch).

Any ideas?

thanks
5  Forum 2005-2010 (read only) / Frequently-Asked Questions / Re: Is it AC or DC? on: February 18, 2009, 12:58:23 am
but how would it act if it was DC? My multimeter gets non-zero numbers regardless of whether I set it to AC or DC. Maybe thats where my problem is.
6  Forum 2005-2010 (read only) / Frequently-Asked Questions / Is it AC or DC? on: February 18, 2009, 12:22:13 am
Whats the best way of determining whether a wire is carrying AC or DC?   Say its just some wire hanging out of a wall that I know nothing else about other than the fact that its carrying some kind of current. Perhaps this is a foolish question, but the rock band by a similar name is making my web searches difficult (even using advanced search features)  smiley-razz . Thanks.
Pages: [1]