Arduino Forum

Forum 2005-2010 (read only) => Hardware => Interfacing => Topic started by: mvgohil on Sep 14, 2009, 11:32 am

Title: lm35dz
Post by: mvgohil on Sep 14, 2009, 11:32 am
hello sir,
  i am using lm35dz for temp. mapping but i can not get mv in o/p. so what is the proper circuit to measure it.  
Title: Re: lm35dz
Post by: AWOL on Sep 14, 2009, 11:42 am
With a 5V analogue reference, you should get about two counts (5 / 1024 = 4.88mV / count) per degree on an analogue input pin.
If you need to measure temperature below zero Celsius, you'll need to offset the negative voltages.