Arduino Forum

Using Arduino => Networking, Protocols, and Devices => Topic started by: KSTC on May 29, 2018, 05:10 pm

Title: "Bluetooth 4.0 iBeacon BLE module" AT Command error 102 in serial monitor
Post by: KSTC on May 29, 2018, 05:10 pm
I'm using iBeacon BLE module. I check status and change name is "OK" but i cann't change password or pin. Error message "102".
Title: Re: "Bluetooth 4.0 iBeacon BLE module" AT Command error 102 in serial monitor
Post by: ieee488 on May 29, 2018, 05:16 pm
I'm using iBeacon BLE module. I check status and name is "OK" but i cann't change password or pin. Error message "102".
How are we suppose to know?

Get the manual and research what error 102 means!



.
Title: Re: "Bluetooth 4.0 iBeacon BLE module" AT Command error 102 in serial monitor
Post by: SUPERETDUPER on Jul 12, 2018, 12:23 am
Have you found the solution I'm getting the same with the HM-10 (specs say nothing)
Title: Re: "Bluetooth 4.0 iBeacon BLE module" AT Command error 102 in serial monitor
Post by: MartynC on Jul 12, 2018, 03:54 pm
The HM-10 uses AT+NAME[P1] where P1 (no brackets) is the new name. If this is not working you may not have a HM-10.