I drive the actuator (red, ground) from a 12V.I connect the white wire from the actuator to arduino pin 11.
the actuator has a PWM interface.
S 2-wire open-loop interface (like B option) with limit switching at stroke endpoints.P Simple analog position feedback signal, no on-board controller.I Integrated controller with Industrial and RC servo interfaces (see L12 Controller Options section). Not available with 10mm stroke length configurations.R RC Linear Servo. Not available with 10mm stroke or 12 volts.L: Mechanical or electrical interface customizationsCustom option codes will be issued by
zoomkat: only one of my 2 12V actuators do still work, so yes I probably fried something