Go Down

Topic: WIP: my UNO clone board + proto shield project (Read 716 times) previous topic - next topic

bitshifter

Jun 27, 2016, 10:04 pm Last Edit: Jul 03, 2016, 05:25 am by bitshifter
This is my UNO clone board and proto shield project.
The main board will be physically compatible with an UNO, meaning it will accept other shields and fit cases which were designed for the UNO.
The proto shield will be fully compatible with an UNO, all the pins are 'brought up' to the shield.
I will update this thread as progress continues.

PARTS LIST: (so far ...)

2x blank prototyping shields (Electronics Salon)
1x assorted 22AWG solid 1-strand wire

--- main board ---

1x female header (6-pin)
2x female header (8-pin)
1x female header (10-pin)
1x female power supply jack (2.1x5.5mm)
1x momentary push button switch (6mm)
1x DIP socket (28-pin)
1x Atmel micro controller (ATmega328P-PU)

--- proto shield ---

1x male header (6-pin)
2x male header (8-pin)
1x male header (10-pin)

PROGRESS UPDATES:

6/27/2016 -- Attached the usual pin headers onto both the main board and the proto shield.

--- main board ---

6/28/2016 -- Fitted and attached the DC power supply jack.
                -- Attached the momentary push button 'reset' switch.

6/29/2016 -- Attached the 28-pin micro controller DIP socket.

7/1/2016 -- Wired pins A0,A1,A2,A3,A4,A5 in yellow, and D0,D1,D2,D3,D4 in blue.

7/2/2016 -- Wired pins D5,D6,D7,D8,D9,D10,D11,D12,D13 in blue.

liuzengqiang

Any crystals you're using? Without crystals, uploading sketch at 115200 will be difficult.
Serial LCD keypad panel,phi_prompt user interface library,SDI-12 USB Adapter

Go Up