Go Down

Topic: arduino ethernet icsp pin pblm (Read 343 times) previous topic - next topic

ctabdusamad

Hai bros....

I purchased one arduino ethernet shield on last week.
 
But it has some problem, basically the icsp pin 5 and 6 has shorted by soldering by manufacturer.

 So any one help me it is correct or not?
















CrossRoads

Whatever you posted is not viewable.
The short is probably not correct. Look around, see if there some solder where there shouldn't be.
6 is Gnd, 5 is Reset, if Reset is held low things are not going to work.
Designing & building electrical circuits for over 25 years.  Screw Shield for Mega/Due/Uno,  Bobuino with ATMega1284P, & other '328P & '1284P creations & offerings at  my website.

Go Up