Go Down

Topic: SIM900 (AT+SAPBR=3,1,“CONTYPE”,“GPRS“) returns ”ERROR" (Read 471 times) previous topic - next topic


I am using SIM900 GSM module which connected with Arduino MEGA 2560. When I send the following command (AT+SAPBR=3,1,"CONTYPE","GPRS") to set up connection type of GPRS, I got response "ERROR".

Command sequences that I send are here:

Code: [Select]

**Commands are here**         **Responses are here**

// See if the SIM900 is ready
AT                                  OK

// SIM card inserted and unlocked?
AT+CPIN?                            +CPIN: READY

// Is the SIM card registered?
AT+CREG?                            +CREG: 0,1

// Is GPRS attached?
AT+CGATT?                           +CGATT: 1

// Check signal strength - should be 9 or higher
AT+CSQ                              +CSQ: 14,0

// Set connection type to GPRS
AT+SAPBR=3,1,"Contype","GPRS"       ERROR

Could you please help to understand what is the issue? Note that I checked SMS and RING and that works fine. the problem is only related to the mentioned command.



i solved this by deleting  (") s in the line like and writing contype and gprs in capital letters. you can send this via terminal



Go Up