Go Down

Topic: *SOLVED* Using my Arduino's logic to now control the motor (Read 913 times) previous topic - next topic

Kuggle55

Apr 06, 2012, 03:57 pm Last Edit: Apr 07, 2012, 07:14 am by Haunted360 Reason: 1
Hi. This is a recovery of this old thread I started here: http://arduino.cc/forum/index.php/topic,72791.msg545937.html#msg545937
However, I now would like to learn how to use my Arduino to control the motor, rather than using a switch, such as the way mentioned here: http://arduino.cc/playground/Main/DCMotorControl

Would anyone like to share how it works?
It says the schematic is wrong. So I dont know.


I believe the Arduino would trigger the transistor (HIGH), and the transistor would then trigger the relay.
I can share my current schematic should you need it to help me out.

All I need is to replace my switch (turns the motor on and off), and replace my other switch that sets the motors direction with digital logic.
From there, I can figure things out to finish my slot loading drive :)


Thank you.

Kuggle55

SOLVED

I just was not thinking right and I had the pinstate set as an OUTPUT still :smiley-roll-blue:

Go Up
 


Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

Arduino
via Egeo 16
Torino, 10131
Italy