Pages: [1]   Go Down
Author Topic: Ardweeny programing  (Read 575 times)
0 Members and 1 Guest are viewing this topic.
costa mesa, CA, united states
Offline Offline
Full Member
***
Karma: 0
Posts: 135
/* no comment*/
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

I tried to program an ardweeny(http://www.solarbotics.com/product/kardw/) for the first time and an error appeared:
 
avrdude: stk500_getsync(): not in sync: resp=0x00

I tried again and had the same problem.
Any help is needed.
Thanks in advance,
Jaredpi
Logged

Gosport, UK
Offline Offline
Faraday Member
**
Karma: 21
Posts: 3113
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Avrdude can't communicate with your ardweeny (of course, you knew that because your research would have told you).

Do you have the right com port selected? The right board type?
Logged

Offline Offline
Jr. Member
**
Karma: 1
Posts: 74
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Depending on your USB to serial adapter, you might not have auto-reset hooked up to the Ardweeny. In that case, you have to reset it manually with the push button at the right time. Here are some instructions:

http://andrewmemory.wordpress.com/2011/01/30/using-an-arduino-serial-usb-board-with-an-ardweeny/
« Last Edit: April 09, 2012, 12:47:17 pm by AndyCC » Logged

Pages: [1]   Go Up
Jump to: