Pages: [1]   Go Down
Author Topic: Hampton Bay Fan-9T Control  (Read 1577 times)
0 Members and 1 Guest are viewing this topic.
Offline Offline
Newbie
*
Karma: 0
Posts: 2
weeeeeee
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

I am looking to control my ceiling fan, it is currently operated by an RF remote that works on a 303.8MHz frequency. The channels can be set manually with dip switches. What I would like to know is there a shield or some way to interface with the fan using an arduino?

Thanks in advance for any help on the matter.

Mark
Logged

Offline Offline
Newbie
*
Karma: 0
Posts: 1
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

hi,

Since the standard remotes are usually 315 mhz, may be kinda hard to make another one. Instead you can use a relay board and connect its switches in parallel with the buttons on the remote. I have done this before. solder the wiring inside the remote, make a little hole on the side of the plastic, glue a tiny female connector. then you do the rest outside, and connetc to it.

Let me know if i wasnt very clear
Logged

Pages: [1]   Go Up
Jump to: