Go Down

Topic: just use the chip from the arduino (Read 912 times) previous topic - next topic


is it possible to just use the admega chip from the arduino after creating a circuit?  or do i need a new arduino for each device i build?


You can program the chip, then plug it into your project board ( which just needs a crystal, a few caps and a 5v supply )

45 years of editing projects with a knife and soldering iron, then I found Arduino !

James C4S

Capacitor Expert By Day, Enginerd by night.  ||  Personal Blog: www.baldengineer.com  || Electronics Tutorials for Beginners:  www.addohms.com


Don't forget the 10K reset pullup resistor.
Designing & building electrical circuits for over 25 years.  Screw Shield for Mega/Due/Uno,  Bobuino with ATMega1284P, & other '328P & '1284P creations & offerings at  my website.

Go Up

Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

via Egeo 16
Torino, 10131