Pages: [1]   Go Down
Author Topic: Get hex from arduino ide?  (Read 459 times)
0 Members and 1 Guest are viewing this topic.
Offline Offline
Newbie
*
Karma: 0
Posts: 4
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Hello.

Is it possible to get file with hex code of my Wire script from arduino ide under ubuntu linux?
Logged

Seattle, WA USA
Offline Offline
Brattain Member
*****
Karma: 549
Posts: 46113
Seattle, WA USA
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Yes. Enable verbose output, to see where the hex file is created. What are you planning to do with the hex file?
Logged

Offline Offline
Newbie
*
Karma: 0
Posts: 4
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

I've found very useful to write tiny programs with arduino ide. So i'm going to fill avr programmer with hex, compiled by arduino ide, because my arduino uno r3 doesn't want to work as isp programmer in any manner (i've tried: capacitor 100 uF between reset and +5V, resistor 110 - 220 ohm between reset and ground, cut off "reset-en" wire; all with arduino isp sketch from "examples").
Logged

Denmark
Offline Offline
Edison Member
*
Karma: 35
Posts: 1029
Happy Hobbyist
View Profile
WWW
 Bigger Bigger  Smaller Smaller  Reset Reset

Quote
(i've tried: capacitor 100 uF between reset and +5V, resistor 110 - 220 ohm between reset and ground, cut off "reset-en" wire; all with arduino isp sketch from "examples").

Did you try 10uF between reset and ground, or resistor between reset and +5V.

Also it would be a good idea to use version 0022, because there are some changes in the 1.00 that causes trouble

If you don't want to use an old version, take a look at this

http://arduino.cc/forum/index.php/topic,99394.0.html
« Last Edit: April 16, 2012, 07:53:16 am by Erni » Logged

Offline Offline
Newbie
*
Karma: 0
Posts: 4
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

i've tried all possible combinations of arduino ide version, arduino isp script and capacitors/resistors on different lines
it doesn't work - i get "programmer is not responding" of "programmer is out of sync" errors. smiley-cry
Logged

Offline Offline
Newbie
*
Karma: 0
Posts: 4
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Finally, it works, thank you.
Was there an inchip defect or problem in electrical contacts, who knows. But i've replaced one chip with another and everything is fine for now.
Logged

Pages: [1]   Go Up
Jump to: