Go Down

Topic: EMC and RF Immunity (Read 796 times) previous topic - next topic

fiddler

I have just had an interesting experience of having some severe noise issues on a small micro controller.
In the end it was mains hum and a speed drive (located very close by) causing the hiccups.

Anyway I started wondering if there is a reasonable affordable way of doing some testing for EMC and RF issues.

Most of what I have found on the net is at the very wrong end of the cost scale, however I found this hand test tool at www.empulse.co.uk

Anyone got some real life experience in this field they would want to share and some suggestion for testing


Grumpy_Mike

Any sort of spectrum analyser can be used, I know these are not cheap but you can make some low cost ones with radio modules. I think there was one in the exhibition section recently.

Go Up
 


Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

Arduino
via Egeo 16
Torino, 10131
Italy