Go Down

Topic: quick question about USB elm327 (Read 2049 times) previous topic - next topic

I'm looking for a cheap elm327 and that looks like it's gonna be a USB one like this. Even though its usb, does it have a serial output that I can interface easily with the arduino? Say if I cut off the end of the cord, will there be wires that can interface easily with it? Thanks.

cyclegadget


It is unlikely that you can use the "USB" signals although I am not positive but, if you can take the box apart and get to the ELM chip rx, tx then you might be able to do something. I have found information in the past that suggested that the ELM chip is based on a PIC chip.
Good links: Eagle tutorial= http://www.youtube.com/playlist?list=PLDE1858BD83D19C70
General Arduion tutorials = http://tronixstuff.wordpress.com
http://www.gammon.com.au/forum/bbshowpost.php?bbtopic_id=123

n1spx

Look at this - http://www.obdsol.com/stn1110/

It's fully ELM compatible and has TTL-level serial for interfacing to an Arduino/ATMega.
They also give samples.

I have used these and it's as simple as it gets to interface with the Arduino.

Go Up
 


Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

Arduino
via Egeo 16
Torino, 10131
Italy