Pages: [1]   Go Down
Author Topic: enc28j60 chip and library  (Read 1734 times)
0 Members and 1 Guest are viewing this topic.
Offline Offline
Newbie
*
Karma: 0
Posts: 1
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

I recently bought a enc28j60 chip
http://iteadstudio.com/store/index.php?main_page=product_info&cPath=18&products_id=224
and I've tryed to connect it using this libary
http://jeelabs.net/projects/cafe/wiki/EtherCard
and it doesn't connect
can anyone help me with the wiring ( wol? , clk?, ...)
and is that the right libary i need?
Logged

Offline Offline
Newbie
*
Karma: 0
Posts: 2
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

For the uno
Vcc --> 3.3v
Gnd --> Gnd
SI  --> D11
SO  --> D12*
SCK --> D13
CS  --> D8
The enc29j60 is a 3.3 volt chip but it has 5 volt tollerent inputs so you should be able to connect it directly to an Uno but the SO pin may cause problems and need to be level shifted up to 5v. Ethercard is the libary i use for the enc29j60 chip.
Logged

0
Offline Offline
Shannon Member
****
Karma: 206
Posts: 12048
Arduino rocks
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Look at the open source Nanode project for an example circuit using the ENC28J60: http://solderpad.com/monsonite/nanode/
Logged

[ I won't respond to messages, use the forum please ]

Pages: [1]   Go Up
Jump to: