Pages: [1]   Go Down
Author Topic: 5x7 DOT MATRIX DISPLAY  (Read 2894 times)
0 Members and 1 Guest are viewing this topic.
Offline Offline
Newbie
*
Karma: 0
Posts: 20
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

I am multiplexing a 5 column and 7 rows dot matrix. I connected like how this site connect. Direct connection http://arduino.cc/playground/Main/DirectDriveLEDMatrix . However i only uses 12pins. And for the code
http://hanez.org/arduino-ta07-11-5x7-dot-matrix-display.html i use exactly the same. Display do come out, but it make no sense to me -
Dont look like a alphabet, just random jumping .  BTW i'm using a common cathode 5x7 dot matrix. Maybe there is some problem with that?
Logged

Manchester (England England)
Offline Offline
Brattain Member
*****
Karma: 620
Posts: 33991
Solder is electric glue
View Profile
WWW
 Bigger Bigger  Smaller Smaller  Reset Reset

That tutorial is bad because there is no current limiting resistors on the LEDs, this could destroy your arduino. Do you have some in? If so what value and where?
http://www.thebox.myzen.co.uk/Tutorial/LEDs.html

Quote
i'm using a common cathode 5x7 dot matrix.
A matrix is common anode or common cathode depending on the way round you look at it.

Quote
Display do come out, but it make no sense to me
So set the code so that just one LED is to be on in a known place and see if it comes on in the place you expect it.
Logged

Offline Offline
Newbie
*
Karma: 0
Posts: 15
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

There is a tutorial for controlling two 5x7 dot matrix LEDs at LucidTronix: http://lucidtronix.com/tutorials/18.  They use current-limiting resistors, and shift registers so it only take three signal wires.. They have an Arduino library you can download that can take text, or set individual pixels.
Logged

Show Your Work
Offline Offline
Edison Member
*
Karma: 14
Posts: 1095
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Since this thread was resurrected I am going to mention that Maxim has a part that does specifically what the original poster asked for, it controls 1-4 5x7 matricies.  Who would have thunk it?

http://datasheets.maximintegrated.com/en/ds/MAX6952.pdf

Maxim has a bit of a premium on this chip but you can always ask for a sample.
« Last Edit: April 07, 2013, 02:46:16 am by JoeN » Logged

I have only come here seeking knowledge. Things they would not teach me of in college.

Pages: [1]   Go Up
Jump to: