Go Down

Topic: Burning the bootloader in a wildthumper (DAGU) with a parallel programmer (Read 1 time) previous topic - next topic

pinguino_vikingo

Hi guys!!!!

I'm using a wildthumper board like this


http://www.robotshop.com/dagu-wild-thumper-dual-15a-motor-robot-controller.html

but I can't upload a new program in it. So, I need re-installing the bootloader to solve the problem.

I've read this page: http://arduino.cc/en/Hacking/Bootloader where explain how I must do it. Unluckily I don't have a AVR-ISP, USBtiniISP or another arduino board neither, so I've thought construct a parallel programmer as say the following page: http://arduino.cc/en/Hacking/ParallelProgrammer.

The point is: Could I use the parallel programmer to burn the bootloader in the wildthumper?? and if I can, Where must I connect the parallel programmer?? maybe in the ISP port?? and How is the correct conexion?? i.e. wich pin is the "pin 1" how we can see in the figure who is here--> http://arduino.cc/en/Hacking/ParallelProgrammer.

Thank you for your time and your attention.

Go Up
 


Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

Arduino
via Egeo 16
Torino, 10131
Italy