Go Down

Topic: Current Consumption with different RAM (Read 490 times) previous topic - next topic



I am not a hardware expert. I am in the normal mode of Uno. (No sleep or power saver mode). I want to know if it consumes the same amount of power if i use 50% RAM or 100% RAM? does it matter how computationally intensive my code is ?



Neither make any difference, even if your code is doing "nothing" it still runs one instruction every 65nS.

You can however reduce power in other ways if it's important to do so.

Rob Gray aka the GRAYnomad www.robgray.com


Read and writing RAM continuously may use slightly more power than running a loop that does no RAM reads/writes, however I expect the difference would be small.
Formal verification of safety-critical software, software development, and electronic design and prototyping. See http://www.eschertech.com. Please do not ask for unpaid help via PM, use the forum.


Also its not just the microcontroller that takes current - the 8u2 that interfaces USB to serial is also consuming significant power.

If you want to really optimize the power consumption you'll need a board without the USB/serial interface built-in.

The microcontroller power consumption is proportional to clock frequency (all else being equal),  and increases with supply voltage, so that the 8MHz 3.3V Pro Mini consumes about 5mA compared to the Duemilanova's 25mA (where the clock is 16MHz, voltage 5V and there is a FDTI serial chip).
[ I will NOT respond to personal messages, I WILL delete them, use the forum please ]

Go Up

Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

via Egeo 16
Torino, 10131