Go Down

Topic: Xbee Communication problems (Read 253 times) previous topic - next topic

nothunt

Hi!

i´m developing a project that has 2 Xbees XB24-B on the respective shields attached to 2 Arduinos MEGA 2560
got the 1st on Serial 1 and the other on the serial 3.
. Im using the API1.

The thing is that i cant get full duplex communication.

I´ve got the code for sending and receiving under conditions inside the loop. But the only result is partial data loss and sometimes even total data loss.

Can somebody give some enlightenment on this issue    =( =( =( =( =(

faludi

What is your addressing setup on the XBees (ATDH and ATDL)? Also what version of the firmware are you using (ATVR)?

Go Up
 

Quick Reply

With Quick-Reply you can write a post when viewing a topic without loading a new page. You can still use bulletin board code and smileys as you would in a normal post.

Warning: this topic has not been posted in for at least 120 days.
Unless you're sure you want to reply, please consider starting a new topic.

Note: this post will not display until it's been approved by a moderator.
Name:
Email:

shortcuts: alt+s submit/post or alt+p preview