Go Down

Topic: When I connect to Processing my RF loses range (Read 360 times) previous topic - next topic

nomuse

Odd problem.  Apparently powering an RF receiver from the USB port (via the Arduino) isn't the best way to get a strong signal.  On my laptop, the same circuit has a quarter of the range.  If I try to run on batter, even worse.  But conditions improve if I shut off the Processing sketch the Arduino is outputting to!

I might go back to using analog pins.  See if that improves things.

Go Up
 


Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

Arduino
via Egeo 16
Torino, 10131
Italy