Pages: [1]   Go Down
Author Topic: Servo or stepper?  (Read 378 times)
0 Members and 1 Guest are viewing this topic.
Offline Offline
Karma: 0
Posts: 6
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

I have no experience with either servos or stepper motors and I'd like to find out which type is better suitable for my task. I need the motor to 1) be as small as possible, 2) rotate in an arc about 170 deg, than back to zero, on cue. It's a lightweight task, there's no load on the shaft. Accuracy is not essential, +-5 deg won't make a difference. Should I use a servo or a stepper motor? I'll be using it with the Uno. Any suggestions as to motor/shield etc. welcome. Thanks.

Massachusetts, USA
Offline Offline
Tesla Member
Karma: 212
Posts: 8967
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

 If you used a stepper you would need to add some way to sense the zero position so I'd use a hobby servo.

You also don't need a driver/controller to drive it, just a separate 5 or 6 volt power source (they tend to draw more power than the Arduino power supply can easily handle).

Send Bitcoin tips to: 1L3CTDoTgrXNA5WyF77uWqt4gUdye9mezN
Send Litecoin tips to : LVtpaq6JgJAZwvnVq3ftVeHafWkcpmuR1e

Pages: [1]   Go Up
Jump to: