Go Down

Topic: Arduino Mega Replacement components (Read 967 times) previous topic - next topic

Hi, I have two burnt-out components on my Arduino Mega. I found them on the online schematic, but I'm not sure where to look for them.

They are:

D1:
Quote
DIODE-SMB (DIODE-)

C6:
Quote
CPOL-EUSMCD (CPOL-EU)


I looked at the top of the components and they had the following labels:

D1:
Quote
GW
4007


C6:
Quote
A476D
10F60


Does anyone know where I can find replacement parts?

CrossRoads

Digikey.
Search for 1N4007 in SMB package.
Search for aluminum cap in surface mount package, probably 100uF, 25V, maybe 5mm?
Designing & building electrical circuits for over 25 years.  Screw Shield for Mega/Due/Uno,  Bobuino with ATMega1284P, & other '328P & '1284P creations & offerings at  my website.

I think I found an appropriate capacitor:
Quote

Manufacturer:   Murata Electronics North America
Manufacturer Part Number:   ECASD91B107M012K00
Description:   CAP ALUM 100UF 12.5V 20% SMD
Lead free / RoHS Compliant


However, SMB packaged diodes for some reason aren't the same size as the one I measured on the board. It appears to match an SMA packaged diode.

I found this diode which appears to be the correct size:
Quote

Manufacturer:   Diodes Inc
Manufacturer Part Number:   S2BA-13-F
Description:   RECTIFIER GPP 100V 1.5A SMA
Lead free by exemption / RoHS Compliant


Is there anything glaring that would suggest why either of these won't work (I'm a mechanical engineer normally so I don't have a lot of electronics experience)?

CrossRoads

If they fit on the board, they will do fine.

How did you damage the input power section?
Designing & building electrical circuits for over 25 years.  Screw Shield for Mega/Due/Uno,  Bobuino with ATMega1284P, & other '328P & '1284P creations & offerings at  my website.

A battery pack had the red wired as ground and black as hot, so I accidentally plugged it in backwards :( These were the only two components which had visible damage, hopefully the board will work after I replace them.

CrossRoads

Oooh, nasty!
Hopefully the diode took the brunt of it.
Designing & building electrical circuits for over 25 years.  Screw Shield for Mega/Due/Uno,  Bobuino with ATMega1284P, & other '328P & '1284P creations & offerings at  my website.

Osgeld

Quote
Description:   RECTIFIER GPP 100V 1.5A SMA


SMA is smaller than SMB but it should fit on the pads enough to solder
http://arduino.cc/forum/index.php?action=unread;boards=2,3,4,5,67,6,7,8,9,10,11,66,12,13,15,14,16,17,18,19,20,21,22,23,24,25,26,27,28,29,30,86,87,89,1;ALL

Got the two parts on and the chip works like a charm :)

Go Up
 


Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

Arduino
via Egeo 16
Torino, 10131
Italy