Go Down

Topic: Using ArduinoISP mode to program most Atmels Was:Help 328p stuck running in 8mhz (Read 774 times) previous topic - next topic

3DLPrint

Hi all,
I have followed the http://arduino.cc/en/Tutorial/ArduinoToBreadboard and http://arduino.cc/en/Tutorial/ArduinoISP  with 1.0.
I programmed one blank 328p with a bootloader using my arduino as an ISP with no problems at all, but the second chip I put on the breadboard and programmed is stuck in 8mhz mode ( I uploaded the blink and it slow flashing the LED ).
I have placed the problem chip in the arduino and flashed the HEX file from hardware\arduino\bootloaders\atmega\ATmegaBOOT_168_atmega328.hex
to it by ArduinoUploader (avrdudde), but the problem remains. I know it may be the fuses, but what are the correct ones for a Duemillanove w/FTDI and how to set them without an AVR Programmer ( I have no parallel port )? I have tried numerous times to reflash the problem chip on a breadboard with an external 16Mhz crystal, but it fails. I can only flash it when I remove the crystal and capacitors, but it is running again at 8Mhz.

Thanks!

P.S. I just was able to run avrdude from command prompt:

avrdude: verifying ...
avrdude: verification error, first mismatch at byte 0x0000
        0xff != 0x0c
avrdude: verification error; content mismatch

3DLPrint

Ok, Solved my own problem.
Here it goes:
Download AVRDudeGUI and set it up like below. Upload  the ArduinoISP sketch to your arduino and connect the breadboarded blank Atmel328p like in the http://arduino.cc/en/Tutorial/ArduinoToBreadboard or http://arduino.cc/en/Tutorial/ArduinoISP . Now comes the fun part! Erase Chip. Read/write the fuses, read the lock. If you need to upload the bootloader use the "Flash" section to select a HEX file and use the Erase-Write-Verify. I indeed had the wrong fuses setup and the correct ones are in the image.

Thanks for looking and maybe this can go in the Wiki.

3DLPrint

Go Up
 


Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

Arduino
via Egeo 16
Torino, 10131
Italy