Pages: [1]   Go Down
Author Topic: Problems with the sm5100b GSM shield  (Read 427 times)
0 Members and 1 Guest are viewing this topic.
Offline Offline
Newbie
*
Karma: 0
Posts: 11
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

I have pins 2/3 mapped to the tx/rx pins and have a console running on my arduino as I was originally getting garbage using the sample sketch provided by sparkfun.  My hunch was that the baud rate was not properly set on the sm5100b.  Connecting via a terminal at 115200 i now am getting commands returning from the GSM module, but it just continuously spits out +CME ERROR: 60.  Any ideas?
Logged

Offline Offline
Newbie
*
Karma: 0
Posts: 11
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

found my problem, in order for the jumpers to work you have to have an empty sketch loaded on the board.
Logged

Pages: [1]   Go Up
Jump to: