Go Down

Topic: Actual MCU in Arduino NANO (Read 550 times) previous topic - next topic

CustomDev

May 23, 2012, 03:21 pm Last Edit: May 23, 2012, 03:48 pm by CustomDev Reason: 1
Can anyone tell me what is the MCU on the Arduino NANO 3, is it an ATMEGA328p-au or an ATMEGA328-au?

johnwasser

look in boards.txt:

nano328.build.mcu=atmega328p
Send Bitcoin tips to: 1L3CTDoTgrXNA5WyF77uWqt4gUdye9mezN
Send Litecoin tips to : LVtpaq6JgJAZwvnVq3ftVeHafWkcpmuR1e

The Clever Monkey


Can anyone tell me what is the MCU on the Arduino NANO 3, is it an ATMEGA328p-au or an ATMEGA328-au?


http://arduino.cc/en/Main/ArduinoBoardNano (From "Hardware" off the main page.)
I yield() for co-routines.

James C4S


http://arduino.cc/en/Main/ArduinoBoardNano (From "Hardware" off the main page.)


The hardware page does not make it clear if the ATmega328P or just Atmega328 is being used, which is why the OP was asking.
Capacitor Expert By Day, Enginerd by night.  ||  Personal Blog: www.baldengineer.com  || Electronics Tutorials for Beginners:  www.addohms.com

The Clever Monkey

#4
May 25, 2012, 03:28 am Last Edit: May 25, 2012, 03:30 am by The Clever Monkey Reason: 1


http://arduino.cc/en/Main/ArduinoBoardNano (From "Hardware" off the main page.)


The hardware page does not make it clear if the ATmega328P or just Atmega328 is being used, which is why the OP was asking.


It says: "Arduino Nano 3.0 (ATmega328)" on that page.

[Later]

Oh, I see what you are saying. I thought it was a 328/168 question. My mistake.

AFAIK, 328P everywhere, yes.
I yield() for co-routines.

Go Up