Go Down

Topic: Actual MCU in Arduino NANO (Read 860 times) previous topic - next topic

aherrera

May 23, 2012, 03:21 pm Last Edit: May 23, 2012, 03:48 pm by CustomDev Reason: 1
Can anyone tell me what is the MCU on the Arduino NANO 3, is it an ATMEGA328p-au or an ATMEGA328-au?

johnwasser

look in boards.txt:

nano328.build.mcu=atmega328p
Send Bitcoin tips to: 1G2qoGwMRXx8az71DVP1E81jShxtbSh5Hp

clvrmnky


Can anyone tell me what is the MCU on the Arduino NANO 3, is it an ATMEGA328p-au or an ATMEGA328-au?


http://arduino.cc/en/Main/ArduinoBoardNano (From "Hardware" off the main page.)
I yield() for co-routines.

cmiyc


http://arduino.cc/en/Main/ArduinoBoardNano (From "Hardware" off the main page.)


The hardware page does not make it clear if the ATmega328P or just Atmega328 is being used, which is why the OP was asking.
Capacitor Expert By Day, Enginerd by night.  ||  Personal Blog: www.baldengineer.com  || Electronics Tutorials for Beginners:  www.addohms.com

clvrmnky

#4
May 25, 2012, 03:28 am Last Edit: May 25, 2012, 03:30 am by The Clever Monkey Reason: 1


http://arduino.cc/en/Main/ArduinoBoardNano (From "Hardware" off the main page.)


The hardware page does not make it clear if the ATmega328P or just Atmega328 is being used, which is why the OP was asking.


It says: "Arduino Nano 3.0 (ATmega328)" on that page.

[Later]

Oh, I see what you are saying. I thought it was a 328/168 question. My mistake.

AFAIK, 328P everywhere, yes.
I yield() for co-routines.

Go Up