...8 bit (256 colors) only
ITDB02 default use the 8bit mode , and if you need the 16 bit mode, you can tear the LCD screen down form the board , and move the R2 resistor to R1 to change the data mode. When you use the 8bit mode , the DB8-DB15 is used ,please remember to pull the DB0-DB7 to GND.
And Sir you were also wrong about the data bus width...
Hello,The display you got, the 3.2"WD is a 16 bit only display (65.000 colors)The Arduino shield you got is to be used with an Arduino Uno and is 8 bit (256 colors) onlyThe Library supports both, but to use this display you need the Mega shield:http://www.exp-tech.de/product_info.php?info=p535_itead-studio-itdb02-arduino-mega-shield-v2-0.htmlAnd an Arduino Mega board.On the Arduino uno and you current shield you can only use 8 bit compatible displays such as:http://www.exp-tech.de/product_info.php?info=p226_iteadstudio-itdb02-2-4d-2-4---tft-lcd-for-arduino.htmlGr. Remco
3.2 LCD runs really slow on 8 bits, so most of 3.2 LCD don't use 8 bits.
Get a 2.4'' LCD with 8 bits, so you have enough pins for other functions like SD card and touch panel. and only use a 3.2 LCD with arduino MEGA.
Sir I wasn't referring to you. I was referring to ...
Please enter a valid email to subscribe
We need to confirm your email address.
To complete the subscription, please click the link in the
email we just sent you.
Thank you for subscribing!
via Egeo 16