Using arduino software on non-arduino minimum hardware board

| Arduino Forum :: Using Arduino :: Project Guidance :: Using arduino software on non-arduino minimum hardware board

Pages: [1] Go Down

	Author	Topic: Using arduino software on non-arduino minimum hardware board (Read 236 times)
0 Members and 1 Guest are viewing this topic.

lightaiyee

Offline

Jr. Member

Karma: 0

Posts: 64

Using arduino software on non-arduino minimum hardware board

« on: June 02, 2012, 07:17:15 pm »

Bigger

Smaller

Reset

Hi arduino experts,

I am new to Arduino but very happy with what I can do with the Arduino IDE despite being a newbie. Arduino consists of hardware and software. I would like to know if it is possible to write software using Arduino IDE first, program the Atmel MCU and finally put the MCU onto a cheaper minimalist hardware board which is non-Arduino. I am asking this question from the point of commercializing products.

I have never done AVR C programming. So, if Arduino IDE can do the job as described above, I cannot see any reason why I should use AVR C anymore.

Thank you.