Go Down

Topic: power for arduino (Read 508 times) previous topic - next topic

boyma

hello
i have two accumulators,1:6V,10A; 2:3V,7A
Can i join them consequentially and use for arduino power?

dc42

Your Arduino may well use a low-dropout regulator (that's what is specified on the parts list for the Uno), so you can probably use just the 6v one. If your Arduino doesn't use a LDO regulator, use an external LDO regulator instead.
Formal verification of safety-critical software, software development, and electronic design and prototyping. See http://www.eschertech.com. Please do not ask for unpaid help via PM, use the forum.

boyma

thx and one more question
i have an h-bridge which connected to arduino,when i connect arduino to usb all working fine,but when i connect accumulators[1)3+6V,15A;2)1.2Vx4, about 10A] nothing happens.i dont understand what the cause of that...
P.S When i had connected 9V Brick Battery,it started work but only for 1-2 min

dc42

Sounds like a wiring issue to me, assuming the accumulator is charged. If the circuit works with a 9v battery, it should work with a 9v accumulator connected in the same way. However, your 1.2Vx4 only gives 5v, which isn't really enough to feed the Vin pin to power the Arduino.
Formal verification of safety-critical software, software development, and electronic design and prototyping. See http://www.eschertech.com. Please do not ask for unpaid help via PM, use the forum.

boyma

acuumulator 6+3V,15A is charged 100%

Go Up
 


Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

Arduino
via Egeo 16
Torino, 10131
Italy