Pages: [1]   Go Down
Author Topic: COM port often cannot be found using Arduino IDE 1.0.1  (Read 343 times)
0 Members and 1 Guest are viewing this topic.
Offline Offline
Newbie
*
Karma: 0
Posts: 18
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

I remember this is not the case for IDE 1.0.0. After upgraded to 1.0.1, I find it often happens. In fact, the COM port can be found using Windows Device Manager. I must disconnect the USB wire and then reconnect to upload sketch.

The OS is Windows 7 64bit. Is there any bugs in USB COM driver?
Logged

Forum Administrator
Cambridge, MA
Offline Offline
Faraday Member
*****
Karma: 9
Posts: 3538
View Profile
WWW
 Bigger Bigger  Smaller Smaller  Reset Reset

Weird.  Which board are you using?  I don't think there's anything different in this between 1.0 and 1.0.1; are you sure it doesn't work the same in both? 
Logged

Pages: [1]   Go Up
Jump to: