Go Down

Topic: how to interface CC2500 transceiver (Read 3190 times) previous topic - next topic

ashish-k

i have this  transceiver:
http://www.mindkits.co.nz/store/new-stuff/low-cost-cc2500-rf-module

but i don't know how to use it with two arduino, btw i have 3.3 v reg and 5 to 3.3 logic level converter.

thankx in advance.
Rock it n loop it.

pylon


ashish-k

thankx 4 ur replay,

but dude it's an arduino shield, and i am using a module (see the diffrance).

thankx.
Rock it n loop it.

pylon

I don't see the difference code-wise.

And hey dude it's everything on that page including the shield schematics. The shield is nothing more than the CC2500 module and some level converters which you told us you already own. If you read it you get to know how to wire things up and you get a library to use it. Quite convenient, I think.

ashish-k

Oops, sry dude, i didn't see that :)

btw thankx for help :D
Rock it n loop it.

Robert10

Hi Guys,

I need to make a FR transmitter device using CC2500 to an existing RF receiver device using 2500 also. I known that there are many library help to connect between CC2500 transceivers. But in my case, it's different. The new CC2500 need to connect to existing CC2500 receiver which has nothing about its technical information.

Please advise me how should I do?

Thanks in advance.

Go Up
 


Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

Arduino
via Egeo 16
Torino, 10131
Italy