Pages: [1]   Go Down
Author Topic: how to interface CC2500 transceiver  (Read 1616 times)
0 Members and 1 Guest are viewing this topic.
Surat,GJ,India
Offline Offline
Newbie
*
Karma: 0
Posts: 35
View Profile
WWW
 Bigger Bigger  Smaller Smaller  Reset Reset

i have this  transceiver:
http://www.mindkits.co.nz/store/new-stuff/low-cost-cc2500-rf-module

but i don't know how to use it with two arduino, btw i have 3.3 v reg and 5 to 3.3 logic level converter.

thankx in advance.
Logged

Rock it n loop it.

Switzerland
Offline Offline
Faraday Member
**
Karma: 108
Posts: 5144
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

I used Google to get this page:

http://www.knutsel.org/2010/04/11/using-the-cc2500-arduino-shield/

Have you seen that?
Logged

Surat,GJ,India
Offline Offline
Newbie
*
Karma: 0
Posts: 35
View Profile
WWW
 Bigger Bigger  Smaller Smaller  Reset Reset

thankx 4 ur replay,

but dude it's an arduino shield, and i am using a module (see the diffrance).

thankx.
Logged

Rock it n loop it.

Switzerland
Offline Offline
Faraday Member
**
Karma: 108
Posts: 5144
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

I don't see the difference code-wise.

And hey dude it's everything on that page including the shield schematics. The shield is nothing more than the CC2500 module and some level converters which you told us you already own. If you read it you get to know how to wire things up and you get a library to use it. Quite convenient, I think.
Logged

Surat,GJ,India
Offline Offline
Newbie
*
Karma: 0
Posts: 35
View Profile
WWW
 Bigger Bigger  Smaller Smaller  Reset Reset

Oops, sry dude, i didn't see that smiley

btw thankx for help smiley-grin
Logged

Rock it n loop it.

Pages: [1]   Go Up
Jump to: