Go Down

Topic: Outpin Toggles when Restarting Arduino Duemilanove (Read 492 times) previous topic - next topic

Jun 16, 2012, 06:14 pm Last Edit: Jun 16, 2012, 06:32 pm by sahir_ismail Reason: 1
Hello,
I am designing a water level controller using Arduino Duemilanove.
When i restart the micro-controller all the output pins toggles turning on the relay (connected to pin 13) for few milliseconds. How can i overcome this problem ?

James C4S

The bootloader flashes the LED on Pin 13 on boot.  So either program the chip directly (removing the bootloader) with a programmer or don't use Pin 13.
Capacitor Expert By Day, Enginerd by night.  ||  Personal Blog: www.baldengineer.com  || Electronics Tutorials for Beginners:  www.addohms.com

#2
Jun 16, 2012, 07:21 pm Last Edit: Jun 16, 2012, 07:24 pm by sahir_ismail Reason: 1
Thanks a lot Sir. I will use pin 11 for triggering relay.

Go Up
 


Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

Arduino
via Egeo 16
Torino, 10131
Italy