Pages: [1]   Go Down
Author Topic: Outpin Toggles when Restarting Arduino Duemilanove  (Read 408 times)
0 Members and 1 Guest are viewing this topic.
Offline Offline
Newbie
*
Karma: 0
Posts: 6
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Hello,
I am designing a water level controller using Arduino Duemilanove.
When i restart the micro-controller all the output pins toggles turning on the relay (connected to pin 13) for few milliseconds. How can i overcome this problem ?
« Last Edit: June 16, 2012, 11:32:07 am by sahir_ismail » Logged

Austin, TX
Offline Offline
Faraday Member
**
Karma: 64
Posts: 6055
Baldengineer
View Profile
WWW
 Bigger Bigger  Smaller Smaller  Reset Reset

The bootloader flashes the LED on Pin 13 on boot.  So either program the chip directly (removing the bootloader) with a programmer or don't use Pin 13.
Logged

Capacitor Expert By Day, Enginerd by night.  ||  Personal Blog: www.baldengineer.com  || Electronics Tutorials for Beginners:  www.addohms.com

Offline Offline
Newbie
*
Karma: 0
Posts: 6
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Thanks a lot Sir. I will use pin 11 for triggering relay.
« Last Edit: June 16, 2012, 12:24:10 pm by sahir_ismail » Logged

Pages: [1]   Go Up
Jump to: