Pages: [1]   Go Down
Author Topic: code for ENC28j60 ethernet shield  (Read 732 times)
0 Members and 1 Guest are viewing this topic.
Moscow, Russia
Offline Offline
Newbie
*
Karma: 4
Posts: 28
View Profile
WWW
 Bigger Bigger  Smaller Smaller  Reset Reset

Hello!
I'm trying to work with spi ethernet shields.
I need to connect my device with computer and to send 48 data bits per 100uS to PC! It's very high... I decided to try with ethernet..
So i have both w5100 and enc28j60. There is a good sketch for w5100 (udpSendRecieve). I think udp is a good idea to make such a large baude?
But w5100 has to much pins. And it will be very difficult to copy that shield scheme to my device. So i heva 2 questions:)


1) is it posibble to have that speed with that controller in udp mode? (about 1-2 mbit per sec)
2) is there simular code for enc28J60?

Thanks a lot!
Logged


Sussex UK / CT USA
Offline Offline
Edison Member
*
Karma: 0
Posts: 1028
Forums forever
View Profile
WWW
 Bigger Bigger  Smaller Smaller  Reset Reset

I don't know if it will work at your speeds, but for more on the older interface....

http://sheepdogguides.com/arduino/ar3nd.htm
Logged

Pages: [1]   Go Up
Jump to: