Loading...
« previous topic   next topic »
Pages: [1]   Go Down
Author Topic: Arduino Uno to Arduino Pro Mini (16mhz/5v)  (Read 615 times)
0 Members and 1 Guest are viewing this topic.
5errated
Offline Offline
Newbie
*
Karma: 0
Posts: 26
View Profile
« on: June 16, 2012, 01:08:51 pm »
 Bigger Bigger Smaller Smaller Reset Reset
Hi!  I'm using my Uno to prototype and test with, and would like to put my completed code onto my pro mini (16mhz/5v) when I'm finished.

My question is: Are the pins the same on the pro mini as they are on the uno?  So if I use analog 3 on my uno, will it be the same pin on the pro mini?  I'm hoping they are, as that will make the transition from the uno to the pro mini much easier.

Thanks!
Logged

Jack Christensen
Grand Blanc, MI, USA
Offline Offline
Faraday Member
**
Karma: 43
Posts: 2515
"We're a proud service of the Lost Electricity Reclamation Agency"
View Profile
WWW
« Reply #1 on: June 16, 2012, 02:07:19 pm »
 Bigger Bigger Smaller Smaller Reset Reset
Yes. To program the Pro Mini, you will need an FTDI cable or breakout board.
Logged
Get the infamous "One Million Ohms" board at tINDIE.com: http://tinyurl.com/BuyMohms

crazydaze
Offline Offline
Newbie
*
Karma: 0
Posts: 11
View Profile
« Reply #2 on: August 26, 2012, 03:32:52 pm »
 Bigger Bigger Smaller Smaller Reset Reset
Or you could use your UNO and save £$prizes
Logged

Pages: [1]   Go Up
Print
« previous topic   next topic »
 
Jump to: