Go Down

Topic: Arduino Uno to Arduino Pro Mini (16mhz/5v) (Read 1 time) previous topic - next topic

5errated

Hi!  I'm using my Uno to prototype and test with, and would like to put my completed code onto my pro mini (16mhz/5v) when I'm finished.

My question is: Are the pins the same on the pro mini as they are on the uno?  So if I use analog 3 on my uno, will it be the same pin on the pro mini?  I'm hoping they are, as that will make the transition from the uno to the pro mini much easier.

Thanks!

Jack Christensen

Yes. To program the Pro Mini, you will need an FTDI cable or breakout board.
MCP79411/12 RTC ... "One Million Ohms" ATtiny kit ... available at http://www.tindie.com/stores/JChristensen/

crazydaze

Or you could use your UNO and save £$prizes

Go Up
 


Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

Arduino
via Egeo 16
Torino, 10131
Italy