Hey guys, anyone using it at 5V? Cause I moved the soldered pin from 3.3 to 5 and could not get it to work. Quite erratically. I did not use any diode cause I believe they are soldered in the pcb board. Any idea?
Quote from: the-rebel-agent on Jun 21, 2012, 05:03 pmDon't Arduino nano have a 3.3v output?yes but .. "when running on external (non-USB) power, the 3.3V output (which is supplied by the FTDI chip) is not available"http://arduino.cc/en/Main/ArduinoBoardNanoso i think i will try to change the solder to the 5volts pin as suggested by Johnwasser (thank you)
Don't Arduino nano have a 3.3v output?
Pls don't use 5 V ,it will destory our module directly ,maybe when you use for a while.the main chip of WTV020-SD module maximum voltage is 3.6V,so work voltage can not beyond 3.6V.
Did work. It was my fault. I forget to read the manual and connect to 5v the Shutdown pin. Works like a charm. Now, I will write a library to control the volume. Keep you posted guys.
In order to reduce power consumption while not in use, the PAM8803 contains shutdown circuitry that is used to turn off the amplifier's biascircuitry. This shutdown feature turns the amplifier off when logic low is placed on the SHDN pin. By switching the SHDN pin connected to GND,the PAM8803 supply current draw will be minimized in idle mode. The SHDN pin cannot be left floating due to the pull-down internal.
Please enter a valid email to subscribe
We need to confirm your email address.
To complete the subscription, please click the link in the
email we just sent you.
Thank you for subscribing!
via Egeo 16