Go Down

Topic: Is there any port limitation with SoftwareSerial on MEGA? (Read 882 times) previous topic - next topic


When using UNO, the SoftwareSerial can use port 2 for RX and port 3 for TX. But it does not work using the same sketch on MEGA. And I tried for a few times and found that the port 50 and 52 can be used.

So is there any limitation to choose RX and TX ports for SoftwareSerial on MEGA?


Have a look at the softwareSerial ref page - http://arduino.cc/en/Reference/SoftwareSerial


Go Up

Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

via Egeo 16
Torino, 10131