Go Down

Topic: Working with AtMega 16U2 [MIDI firmware] (Read 3668 times) previous topic - next topic

Soranne

Hello everyone!

I just got an Arduino R3, so with the new chip atmega 16U2 instead of 8U2 for the previous release.
As far as I understood the only difference between these two chips is just that they have a different amount of memory, am I right?
So a firmware made for the 8u2 would work on the 16u2, or do i need to recompile it?

The real problem I'm facing is that I'm trying to build a midi controler, and I can only find usb midi firmware for the 8u2 and not the 16u2.

Regards,
Soranne
My projects :
- Interfacing with Minitel : http://www.arduino.cc/cgi-bin/yabb2/YaBB.pl?num=1271350467
- Arduino PIC programmer : http://ardu

tim7

When I tried it I found that binaries compiled for the 8U2 and 16U2 were identical.

Go Up
 


Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

Arduino
via Egeo 16
Torino, 10131
Italy