Go Down

Topic: Using resistances (Read 702 times) previous topic - next topic

ignacillo

Hi, I'm begginer in electronic and I connected a dc motor and a led to digital pins in PWM mode of the arduino board without a resistance (I connceted them directly), I want to know if do that is damaging for the arduino board or only is bad for the Led or the motor that use 5v, for that I think that the motor don't need a resistance. It's true?
Thanks.

Magician

You damaging arduino. Use resistors with leds, for motor you need transistor.

JimboZA


.... for motor you need transistor.


And a diode to take care of the back emf when the motor stops, as explained here.

Johannesburg hams call me: ZS6JMB on Highveld rep 145.7875 (-600 & 88.5 tone)
Dr Perry Cox: "Help me to help you, help me to help you...."
Your answer may already be here: https://forum.arduino.cc/index.php?topic=384198.0

clvrmnky


Hi, I'm begginer in electronic and I connected a dc motor and a led to digital pins in PWM mode of the arduino board without a resistance (I connceted them directly), I want to know if do that is damaging for the arduino board or only is bad for the Led or the motor that use 5v, for that I think that the motor don't need a resistance. It's true?
Thanks.


See here: http://www.arduino.cc/playground/Main/InterfacingWithHardware#Physical_Mechanical
I yield() for co-routines.

Go Up