Go Down

Topic: VGA ports using arduino (Read 966 times) previous topic - next topic


Hi! i have an arduino uno, and i would like to drive a display trough a VGA port.

i searched for some VGA specifications, but im not sure so i will post about this:

if i undestand correctly if i output the pixel colors trough the RED, GREEN, BLUE pins,
i output a High signal on the HSYNC when i reach the end of the line,
i output a High signal on the VSYNC when i reach the end of the picture,
and i wire RGND, GGND, BGND, HSYNC_GND to the ground.

is this really the case? of course i have to make some timing delays so i can output a 320x240 image @60hz

also if it would work, what values shouzld i output on the R, G, B, HSYNC, VSYNC pins?



have you seen this :)? http://www.youtube.com/watch?v=eGhsN9GWh48


so i can output a 320x240 image

well with 8 bit for each of the RG & B components that works out at:- 230K bytes, on a machine with only 2K of ram for everything where are you going to put the image?


its 8bit total, not for RGB individually.


So only 79K to fit in a 2K machine, that is much better?

Go Up

Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

via Egeo 16
Torino, 10131