Pages: [1]   Go Down
Author Topic: Input/Output Easydriver  (Read 661 times)
0 Members and 1 Guest are viewing this topic.
Offline Offline
Newbie
*
Karma: 0
Posts: 6
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Hi everyone!
I'm working on controlling a stepper motor using the Arduino UNO and the easydriver v4.4 driver, but I have a question:
- The driver's power input goes from 7V to 30V. If I supply 12V, does it mean that the motor will receive 12V/phase? The motor I'm using is a 3.3V. Some other motors are 5V and other 12V, ... Does the driver regulate somehow the output leves or what?
- Could I use the output pins of the Arduino to power the easydriver?
- I have a 12V/4800mAH Portable Li-ion Rechargeable Battery. Could I use it simultaneously to power the arduino board and the easydriver?

Thanks in advance for your help!!
Logged

Manchester (England England)
Offline Offline
Brattain Member
*****
Karma: 634
Posts: 34541
Solder is electric glue
View Profile
WWW
 Bigger Bigger  Smaller Smaller  Reset Reset

Quote
does it mean that the motor will receive 12V/phase?
Yes, well it can't get more.

Quote
Does the driver regulate somehow the output leves or what?
It has a chopping relator so once it reaches the current you have set it cuts off. Your motor is not actually designed to run off 3V3, it is just that the resistance of the coils means it gets it's rated current at 3V3. Powering it from a higher voltage is good as it means it can be stepped faster.

Quote
Could I use it simultaneously to power the arduino board and the easydriver?
Yes.
Logged

Offline Offline
Newbie
*
Karma: 0
Posts: 6
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Thanks Grumpy_Mike for your answer.
Another question, if I use the easydriver set at the maximum allowable current (750 mA) and power a 2A motor, what happens? would it work only while the current is lower than 750 mA (a small load)? If I try to move a bigger load, so I try to exceed the 720 mA, would I destroy the driver or it's protected against it?

Thanks again!!
Logged

Manchester (England England)
Offline Offline
Brattain Member
*****
Karma: 634
Posts: 34541
Solder is electric glue
View Profile
WWW
 Bigger Bigger  Smaller Smaller  Reset Reset

If you set the regulator at a certain current you can drive what ever size motor you like but it will only be driven at that set current.
If you try and move a load bigger than that current will move the motor will just stall, no damage to anything.
Logged

Offline Offline
Newbie
*
Karma: 0
Posts: 6
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Thank you very much Grumpy_Mike. You've been so helpful.
Logged

Pages: [1]   Go Up
Jump to: