Go Down

Topic: LCD117 Driver--cant seems to get it working...drawing too much current? (Read 833 times) previous topic - next topic


I've noticed a person above this thread is having the same problem I am. I've tried putting resistor between the voltage supply (5v) but it's not helping.

I've actually got the LCD working about a week ago: I've just hooked the LCD driver in its appropriate pins (ground, 5v, and Rx pin). But now, whenever I hook the ground and voltage source, the Arduino (Uno) turns off.

This is the driver I am using:

Any ideas?


Never mind guys.
It seemed the breadboard I was using was the cause of it.

Carry on.

Go Up

Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

via Egeo 16
Torino, 10131